Beer Flow Meter with Integral LED Counter in UK Pints :: 3/8

SKU: BF3100-000
Beer Flow Meter
0.5 - 10 L/min

7-15 V DC
4 Digit Totaliser (Pints)
3/8” Fittings

  • Measuring Units
  • $231.23
  • $277.48 inc VAT


  • SKU
Beer Flow Meter
0.5 - 10 L/min
7-15 V DC
4 Digit Totaliser (Pints)
3/8” Fittings
Designed primarily for beer measurement this indicating meter is a stand alone product that shows the amount of liquid dispensed since the last reset.  The unit can only be zero'd using a hand held program-mer.  This is not just a simple switch but an intelligent instrument in its own right, poking a metal object in the connector on the display unit will not re-set it. This programmer can be made to work with single units or in groups of devices in a number of establishments. The meter must have power to work but should the device be disconnected the display will flash when power is restored and will continue to do so until the unit is re-set using the programmer. This to indicate to an absent operator, tampering or temporary power loss. The meter will remember the total at power down and continue incrementing from that point when the power is restored.  
Install the meter in a horizontal run of pipe using 3/8” push on John Guest fittings with the arrow on the back of the meter in the direction of the beer flow. Connect power to the socket on the side, 7- 15 volts dc, a “plug” type power supply of the correct rating is ideal. Do not use a 24 volt transformer. We can supply a dedicated PSU for multiple unit installations. The reset key fob must be held very close to the reset window and the button pressed for approximately 3 seconds. This close proximity will ensure that no other meters in the same area are simultaneously reset. The “colon” in the centre of the display will light up if a reset signal is being received. If a count in excess of 999.9 is made the decimal point to the right of the hundred digit will flash. Do not permit the meter to run on gas as this will damage the device. Where possible fit a mechanical air eliminator (FOB detector).



    Flowmeters: 3/8" Beer Meter & Totalising Beer Counter features:

    • 4 Digit totaliser
    • Ideal for beer totalising
    • High speed count
    • IP65 (Nema 4X)
    • Non volatile memory
    • 7 - 15V ac/dc
    • Clear 7mm LED
    • One decimal point
    • 3/8” Fittings
    • 0 - 40°C
    • Competitively priced
    • Power loss indicator
    • Pints or litres display
    • Key fob reset
    • 0.5 to 10 L/Min
    • 0 to 999.9 litres or pints
    • 0.070 kg
    • Power supply for up to16 units


    The principle of operation is very simple. A jet of liquid is directed at a free running Pelton wheel turbine in a specially shaped chamber. The rotation of the rotor is detected with a Hall Effect sensor. The output frequency of these pulses is directly proportional to flow rate and the total number of pulses the total volume passed. The standard bearing material is sapphire as this gives a long trouble free life to the meter. Non-metallic options mean that these meters may also be used with very aggressive chemicals and ultra-pure water